Описание
Stepper motor with a standard interface could be connected with Driver Board easily;A, B, C, D four-phase LED indicates the status of the stepper motor work.
5 line 4 phase can be used for ordinary ULN2003 chip driver, connect to the 2 phase , support the development board,With convenient use, direct docking;Stepper motor with a standard interface, when used directly pluggable.
A stepper motor can move in accurate, fixed angle increments known as steps.
For practical purposes, a stepper motor is a bit like a servo: you can tell it to move to a pre-defined position and can count on getting fairly consistent results with multiple repetitions.
Servos though, are usually limited to a 0-180 degree range, while a stepper motor can rotate continuously, similar to a regular DC motor.
Steppers motors can achieve much higher precision and control over the movement.
Full-speed USB support using Windows standard drivers
Real-time execution
Processors run at maximum speeds
MPLAB IDE compatible (free copy included)
Built-in over-voltage/short circuit monitor
Firmware upgradeable from PC/web download
Totally enclosed
Supports low voltage to 5 volts (1.8v to 5.0v range)
Rated Voltage: DC5V 4-phase
Insulation Resistance: more than the 10MOhm (500V)
Dielectric Strength: 600V AC / 1mA / 1s
Step angle: 5.625 x 1/64
DC Resistance: 200Ohm+/- 7% (25 Celsius)
Reduction ratio: 1/64
Insulation Grade: A
No-load Pull in Frequency: more than the 600Hz
No-load Pull out Frequency: more than the 1000Hz
Pull in Torque: more than the 34.3mN.m(120Hz)
Detent Torque: more than the 34.3mN.m
Temperature Rise: Less than equal 40K(120Hz)
Drive Module Board Size: 1.37 x 1.18 x 0.6 inch
Stepper Motor diameter: 1.06(in)
Stepper Motor lines: 9.45(in)
Material: Plastic Metal
Colour: Green Silver
Size: 28 x 274 mm
Package Contents: 5 x Stepper Motor Controllers
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
5 line 4 phase can be used for ordinary ULN2003 chip driver, connect to the 2 phase , support the development board,With convenient use, direct docking;Stepper motor with a standard interface, when used directly pluggable.
A stepper motor can move in accurate, fixed angle increments known as steps.
For practical purposes, a stepper motor is a bit like a servo: you can tell it to move to a pre-defined position and can count on getting fairly consistent results with multiple repetitions.
Servos though, are usually limited to a 0-180 degree range, while a stepper motor can rotate continuously, similar to a regular DC motor.
Steppers motors can achieve much higher precision and control over the movement.
Full-speed USB support using Windows standard drivers
Real-time execution
Processors run at maximum speeds
MPLAB IDE compatible (free copy included)
Built-in over-voltage/short circuit monitor
Firmware upgradeable from PC/web download
Totally enclosed
Supports low voltage to 5 volts (1.8v to 5.0v range)
Rated Voltage: DC5V 4-phase
Insulation Resistance: more than the 10MOhm (500V)
Dielectric Strength: 600V AC / 1mA / 1s
Step angle: 5.625 x 1/64
DC Resistance: 200Ohm+/- 7% (25 Celsius)
Reduction ratio: 1/64
Insulation Grade: A
No-load Pull in Frequency: more than the 600Hz
No-load Pull out Frequency: more than the 1000Hz
Pull in Torque: more than the 34.3mN.m(120Hz)
Detent Torque: more than the 34.3mN.m
Temperature Rise: Less than equal 40K(120Hz)
Drive Module Board Size: 1.37 x 1.18 x 0.6 inch
Stepper Motor diameter: 1.06(in)
Stepper Motor lines: 9.45(in)
Material: Plastic Metal
Colour: Green Silver
Size: 28 x 274 mm
Package Contents: 5 x Stepper Motor Controllers
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
Весь продукт мы можем отгрузить в течение 5-8 рабочих дней, обычно мы в зависимости от времени заказа клиента для упаковки и отгрузки, мы должны тщательно проверить качество товара перед отправкой, поэтому потребуется некоторое время для обработки. Время доставки: Из-за форс-мажорных факторов: ураганы, дождевые штормы влияют на полеты. Что приводит к задержкам в логистике. Мы честные продавцы, не дадим вам потеряться. Пожалуйста, дайте логистической компании немного времени на обработку, мы ждем, пока посылка дойдет до вашей стороны. Если ваша информация о логистике поступает в местное почтовое отделение: Если местное почтовое отделение не свяжется с вами, пожалуйста, свяжитесь с местным почтовым отделением как можно скорее, чтобы получить посылка. В противном случае, при сверхурочном получении посылок, местное почтовое отделение вернет вашу посылку, что является причиной самоответственности. Время защиты заканчивается: Когда мы закончили отгрузку, если срок защиты продукта истекает, пожалуйста, Продлите срок защиты продукта самостоятельно или свяжитесь с нами, пожалуйста, не открывайте спор напрямую. Ввозные таможенные пошлины: Налоги и сборы не включены в стоимость товара или стоимость доставки. Ответственность за эти расходы несет покупатель. Ввозные таможенные пошлины, налоги и сборы не включены в стоимость товара или стоимость доставки. Ответственность за эти расходы несет покупатель
Если товар поврежден, мы должны связаться в течение 24 часов с момента получения.
Если данный товар находится в вашем распоряжении более 7 дней, он считается пользованным товаром, и мы не производим возврат или замену. Если вы не удовлетворены полученным товаром (неправильный, поврежденный, дефектный или не соответствующий описанию), пожалуйста, верните его в течение 7 дней для замены или возврата денег.По каким-либо личным причинам (выберите недоверие или мне больше не нужен этот товар), возврат расходы по доставке будет нести ответственность покупателя. Мы не принимаем любые предметы с запахами (духи. Дым, и т. Д.)
Все товары ДОЛЖНЫ возвращаться в оригинальной упаковке. Кроме того, НЕОБХОДИМО ПРЕДОСТАВИТЬ номер отслеживания посылки, конкретную причину возврата и ваш номер заказа.На нашем веб-сайте вы найдете всю необходимую информацию о продукте под названием «5 шт. DC 5 в шаговый двигатель контроллеры+ ULN2003 драйвер Модуль платы 28BYJ-48 TE118». Это включает в себя цены, фотографии, видеообзоры, подробное описание и технические характеристики. Наша цель - помочь вам принять информированное решение. Узнайте больше о товаре по артикулуKKHJHMNPLLH - Шаговый двигатель
Характеристики
- Тип
- Гибридные
- Номер модели
- /
- Крутящий Момент
- /
- Ток / Фаза
- /
- Сертификация
- Обязательный сертификат КНР
- Угол Шага (градусы)
- /
- Фаза
- Other